본문 바로가기

삶/좋은생활도움글

메이택 넵튠 (Maytag Neptune) 세탁기 door boot 새로 설치하는 방법

생활상식에 대한 내용입니다. 메이택 넵튠 세탁기의 도어 부분에 곰팡이가 너무 많이 끼어서 갈아끼울려고 부품을 주문했습니다. 대충 $84.98 정도 나오더군요.

사용자 삽입 이미지


여기 교체방법입니다.

사용자 삽입 이미지
[내용출처: http://appliancehelp.hypermart.net/newimages/neptunebootchange44.jpg]

사용하고 있는 모델이 MAH5500인데 자세한 수리에 대한 매뉴얼도 있더군요. 여기에서 다운 받을 수 있습니다.

실제로 가장 도움이 되었던 설치방법입니다.

posted on Oct 21, 2007
FixYa! (100)

Amigaman

Rank:Guru Guru
Rating: 88%, 333 votes
   Remove 2 screws holding door hinge to cabinet and remove door.  Then remove 2 screws opposite these. Grab front panel with thumbs at area of screws you removed and pull outward with thumbs. Panel will pivot forward.  Remove panel from lower clips.  At top of exposed area remove 2 5/16 screws.  Remove brackets under them. 
  Open dispenser and remove 4 screws.  Careful not to drop in dispenser.  Remove dispenser frame assembly.
  You can now raise top of washer to a 90 degree position.
   Now back to front exposed area.  Grab boot where it contacts front and peel out of groove.  Also remove two screws holding light assembly and remove cover.  Remove all 5/16 screws holding front assembly and the ones on top area where it is on a bevel.  Remove front assembly by folding up and onto top. 
  Now we are at the boot.  Remove spring and wire assembly holding boot to drum.  Make note on boot position and spring position.  Remove boot.  Install new boot onto drum.  wrap wire around drum with ends at top.  Now the fun!  Hook spring to on end of wire and using vise-grips,  pull to other end to hook into wire.  It can be done,  honest.
  Now just reverse to reassemble.  should be instructions with boot.   Good luck!

[출처: http://www.fixya.com/support/t221456-maytag_washer_door_boot]


냄새가 많이 날 경우, 냄새를 없애는 방법입니다.

An quick and easy way to "Freshen up" the Neptune washer for odors...,

- Add about 1/2 of a cup of powdered dishwasher detergent into the empty wash/spin basket, just pour it inside. Close the door.

- Select the top fabrics button ( Cotton/Sturdy or Whites ) and the Hot/Cold on the wash/rinse switches.

- Rotate the timer dial to Regular cycle/Heavy ( whites ), then press start.

- While the washer us filling with water, pour a cup of liquid bleach into the detergent compartment.

- After 5 minutes, stop the washer and advance the control dial to the first rinse. Press start and wait 10 seconds. Press stop and advance to the 2nd rinse. Press start and wait for 10 seconds. Press stop and advance to the 3rd rinse. Press start and let the washer complete the cycle through the final spin.

- Select the top fabrics button ( cotton/sturdy or whites ) and the hot/cold on the wash/rinse switches. Rotate the timer dial to heavy. Do not use any detergent or bleach. Then press the start button. This will allow the washer to finish a complete cycle void of bleach and detergent. The Freshen up procedure is now completed.    

Readers Tip:

The new boot has a drain built into it, this drain should be checked once in a while to make sure it is not getting clogged up or restricted. A pipe cleaner works well to clean/check this out.

[내용출처: http://www.applianceaid.com/neptune.html]